Description
Voltage
• Floating outputs on plug-in terminal block for 2.5 mm² (AWG 12) wire
• Output voltage : adjustable from 20 to 29 V.
• Regulation : < 20 mV for a load variation from 0 to 100%.
< 1 mV for a line variation from -10 to +10%.
• Ripple : < 3 mV rms including:
< 5 mV peak to peak of the signal at 100 kHz
< 5 mV peak to peak of the signal at 100 Hz
< 15 mV peak to peak of switching spikes
• Hold-up time : 25 ms at half load and 12 ms at full load (190 V line input).
• Indicator : green power-on LED indicator.
“status, output fault” red LED.
Current
• Max I : 5,5 A in short circuit condition.
5 A from 20 to 29 V
Power
• Max output power : 145 W.
Protection
• Against short circuit protection, by current limit.
• Against overcurrent on primary circuit, by fuse.
• Against overload on outputs, by voltage limit to 33 V.
Other specifications
• Safety : Complies with EN 61010-1, EN61010-2-201 and EN 62368-1.
• EMC : Complies with EN 61000-6-2 and EN 61000-6-4.
• Insulation Class : I.
• Overvoltage Category : II.
• Pollution Degree : 2.
• Installation altitude : < 2000 m.
• Protection level : IP 30.
• Operating temperature : from -10 to +60 °C ; derating : 2.5%/K from +50 °C
• Input voltage : 220-240 VAC (190 to 264 Volts), 50-60 Hz.
• Mains input : 3-pole plug-in terminal block for 2.5 mm² (AWG 12) wire.
• DC ouput : 2-pole plug-in terminal block for 2.5 mm² (AWG 12) wire.
• Power consumption : 170 W max.
• Power factor : 0,99 (built with PFC).
• Dielectric strength : 3000 VAC
1800 VAC from input to chassis.
• Presentation : galvanized steel case and front panel with epoxy finish.
• Mounting : Integral symmetrical DIN rail clips
