Description
Voltage
• Floating outputs on spring terminal block with levers for 2,5 mm² (AWG 12) wires.
• Output voltage : adjustable from 10 to 15 V.
• Regul : < 20 mV for a load variation from 0 to 100%
< 2 mV for a line variation from -10 to+10%.
• Ripple : < 3 mV rms including:
< 2 mV peak to peak of the signal at 100 kHz
< 4 mV peak to peak of the signal at 100 Hz
< 10 mV peak to peak of switching spikes
• Hold-up time : 25 ms at half load and 12 ms at full load (190 V line input).
• Indicator : green power-on LED indicator.
Overheat or overcurrent red LED “status” indicator
Current
• Max I : 5,5 A in short circuit condition.
5 A from 10 to 12 V
4 A to 15 V
Power
• Max output power : 60 W.
Protection
• Short circuit protection, by current limit.
• Against overcurrent on primary circuit by fuse.
• Against overtemperature, by thermal shutdown.
• Cover on input output terminal block.
Remote sensing
Correction of the voltage drop in the wires (4 wires method)
Input on spring terminal block with levers for 2,5 mm² wires (AWG12)
Correction : Max 3 V (1,5 V per wire)
Ripple : < 30 mV for a load variation from 0 to max.
Other specifications
• Safety : Class II, Safety Extra Low Voltage (SELV), complies with EN 61010-1, EN 61010-2-201 and EN 62368-1.
• EMC : Complies with EN 61000-6-2 and EN 61000-6-4.
• Overvoltage Category :II ; Pollution Degree : 2.
• Installation altitude :< 2000 m.
• Protection level : IP 30.
• Operating temperature : from -25 to +60 °C ; derating : 1 W/°C from +40 °C
• Input voltage : 190 to 264 Volts, 50/60 Hz.
• Mains input : spring terminal block with levers for 2,5 mm², (AWG 12) wires.
• Power consumption : 74 W max.
• Dielectric strength: 3000 VAC from input to output.
• Presentation : modular polycarbonate case (6 x 17.5 mm) screenprinted.
• Mounting : Clips package integrated in modular case for DIN rails profile 35×7,5 mm or 35×15 mm.
Removable wall mouting integrated to the case for 4 mm screws
